Klipper
-
Mainsail vs Fluidd: Which Interface Should You Run?
Mainsail vs Fluidd compared for Klipper: install paths, multi-printer setups, macro prompts, cameras and config includes, plus which one to run.
-
Klipper Pressure Advance Calibration Guide, Step by Step
Tune Klipper pressure advance with the TUNING_TOWER test: start 0, factor 0.005 direct drive or 0.020 Bowden, then measure, calculate and verify.
-
Klipper Hardware Requirements: Minimum Host, Board, Sensors
What Klipper needs: a Linux host (Pi Zero 2 W, 3, 4, 5 or x86), a control board whose MCU Klipper builds for, a stable supply, and an optional ADXL345.
-
Klipper vs Marlin Firmware: Setup, Input Shaping, Tradeoffs
Klipper plans motion on a Linux host, Marlin on the printer board. See how config, input shaping and reliability differ, and which suits your printer.
-
Klipper Input Shaper Setup: Wiring and Tuning an ADXL345
Wiring, configuration, and calibration commands for measuring resonance with an ADXL345 in Klipper, plus fixes for the errors that stop a run.
-
How Klipper Works: Host, MCU, and printer.cfg
How Klipper works from G-code to step pulses: host planning, MCU timing, printer.cfg changes, protocol communication, and when to reflash firmware.